Samsung HERMES User Manual

English - 25

SETTING

2. Tighten the compression nut (B) onto the

compression fitting.

Do not over-tighten the compression nut (B).

3. Turn the water on and check for any leakage.

If you find water drops or leakage in the

connection areas, turn off the main water

supply.

Check the connections and, if necessary,

tighten.

4. Flush 1 gallon of water through the filter before

drinking or using the water from the refrigerator.

(Flush approximately 6 minutes.)

To flush, press a large glass or cup against the

water dispenser lever.

Fill the glass, empty it into the kitchen sink after

it is filled, and then repeat.

5. After you turn on the refrigerator, let the ice

maker make ice for 1 to 2 days.

Over that period of time, throw out the first 1 or

2 buckets of ice the freezer makes to ensure all

impurities have been removed from the water

line.

• Only connect the water line to a drinkable

water source.

If you have to repair or disassemble

the water line, cut off 1/4" of the plastic

tubing to make sure you get a snug,

leak-free connection.

• You can test the water line quickly using

a paper cup. Under normal conditions,

the water dispenser can fill a 5.75 oz.

(170 cc) cup in about 10 seconds.

COMPLETING THE SET UP

Now that you have your new refrigerator installed

in place, you are ready to set up and enjoy the

features and functions of the appliance.

By completing the following steps, your refrigerator

should be fully operational.

1. Make sure your refrigerator is in an appropriate

location with reasonable clearance between it

and the wall.

Refer to installation instructions in this manual.

2. Once the refrigerator is plugged in, make sure

the interior light comes on when you open the

doors.

3. Set the Temperature control to the coldest

temperature and wait for an hour.

The freezer will get slightly chilled and the motor

will run smoothly.

Reset the refrigerator and freezer to the

temperatures you want.

4. After you plug the refrigerator in.

It will take a few hours to reach the appropriate

temperature.

You can store food and drinks in the refrigerator

after the temperature is sufficiently cool.

• If condensation or water drops appears

on both sides of fridge door’s central

part, turn the Energy Saving mode off

after removing the condensation.

(See the explanation of the Energy Saving

button in USING THE CONTROL PANEL

on page 24.)

DA68-03013C-04.indb 25

2015. 8. 26. �� 9:21