Samsung WA11R3 User Manual

■

Adjust the legs to level the washer
Be careful not to put in your hand under the legs.

Pull the handles located at the right and left of the 
front side and slide off.

Adjust the height of the machine upward or 
downward.

When the adjustment is finished, push the handles 
to fix the adjusting legs.

The front part is 
lower

Level it by adjustable legs.

The back part is 
lower

Adjust the height by using the adjustable 
rubber or prop at the back.

The left part is 
lower

Adjust the left part by using the adjustable 
legs at the front and the adjustable rubber 
at the back.

The right part is 
lower

Adjust the right part of the washer by 
using the adjustable leg at the front and 
the adjustable rubber at the back.

1.    Remove the adaptor from the water supply hose.

2.    First, using a “+” type screw driver, loosen the four 

screws on the adaptor. Next, take the adaptor and turn 
part(b) following the arrow for gap about 5mm between 
them.

3.    Connect adaptor to the water tap by tightening the screws 

firmly. Then, turn part(b) following the arrow and put (a) 
and (b) together.

4.    Connect the water supply hose to the adaptor. Pull down 

the part (c) of the water supply hose. When the part (c) is 
released, the hose is automatically connected to the 
adaptor making a ‘click’ sound.

5.    Connect the other end of the water supply hose to 

the inlet water valve at the back of the washer. 
Screw the hose clockwise all the way in.

5-1. Connect the other end of the water supply hose to 

the inlet water valve at the top of the washer.

Screw the hose clockwise all the way in.

☞ If the water tap is a screw type, assemble a water 

supply hose that fits to the tap as shown.

After completing connection, if water leaks from the hose, then 
repeat the same steps.

Use the most conventional type of faucet for water supply.

In case the faucet is square or too big, remove the spacing ring 
before inserting the faucet into the adaptor.

a

b

c