Samsung BRB260135WW User Manual

Installation

English

34 

Ins
tallation

STEP 5 Initial settings

By completing the following steps, the refrigerator should be fully functioning.
1.  Remove the PE foam sheet on each shelf corner, which is attached to protect the 

refrigerator during transportation.

2.  Open the door, and check if the interior light lights up.

3.  Remove the PE foam on the magnet 

from the top of the door.

4.  Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be 

slightly chilled, and the motor will run smoothly.

5.  Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready 

for use.

NOTE

When the refrigerator powers on, the alarm will sound. To turn off the alarm, press Freezer 
or Fridge.

STEP 6 Temperature Alarm (applicable models only)

Type 1
•  The refrigerator blinks '- -' on the temperature display with an alarm if the freezer 

compartment is too warm. This may occur if the freezer becomes too warm after there 
has been a power failure.

•  If this happens, press Freezer or Fridge. Whichever warmer temperature is displayed 

for 5 seconds. Then the actual temperature is displayed. To deactivate the alarm, press 
Door Alarm.

Type 2
•  The refrigerator blinks the temperature indicator with an alarm if the freezer 

compartment is too warm. This may occur if the freezer becomes too warm after there 
has been a power failure. To deactivate the alarm, press Freezer or Fridge. 

STEP 7 Final check

When installation is complete, confirm that:
•  The refrigerator is plugged into an electrical outlet and grounded properly.
•  The refrigerator is installed on a flat, level surface with a reasonable clearance from the 

wall or the cabinet.

•  The refrigerator is level and is sitting firmly on the furniture.
•  The door opens and closes freely, and the interior light turns on automatically when you 

open the door.

Untitled-9   34

2017-01-31     6:54:50