Samsung RB37K63612C User Manual

Installation

English

32 

Ins
tallation

STEP 5 Initial settings

By completing the following steps, the refrigerator should be fully functioning.
1.  Remove the PE foam sheet on each shelf corner, which is attached to protect the 

refrigerator during transportation.

2.  Plug the power cord into the wall socket to turn the refrigerator on .
3.  Open the door, and check if the interior light lights up.
4.  Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be 

slightly chilled, and the motor will run smoothly.

5.  Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready 

for use.

NOTE

When the refrigerator powers on, the alarm will sound. To turn off the alarm, press Freezer 
or Fridge.

STEP 6 Temperature Alarm (applicable models only)

•  When the freezer compartment is too warm because there has been a power failure, the 

signal of “- -” flashes on the display.
-  When the Freezer or Fridge button is pressed, the “warmest temperature” which 

has reached in the freezer and fridge compartment is flashed on the display for 5 
seconds.

-  Then the actual temperature is indicated. To deactivate the Temperature Alarm 

function, press Door Alarm again.

•  This warning may operate;

-  When the appliance is turned on.
-  The freezer compartment is too warm due to a power failure.

STEP 7 Final check

When installation is complete, confirm that:
•  The refrigerator is plugged into an electrical outlet and grounded properly.
•  The refrigerator is installed on a flat, level surface with a reasonable clearance from the 

wall or the cabinet.

•  The refrigerator is level and is sitting firmly on the floor.
•  The door opens and closes freely, and the interior light turns on automatically when you 

open the door.

Untitled-7   32

2016-09-05     4:47:14