Samsung External Dispenser French Door User Manual

 

Setting Up

1. Remove the water filter cover ( 

 )

2.  Remove the fixed cap ( 

 ) by turning it counter clockwise. 

Keep the cap in a safe place for later use if you don’t use the 

filter.

3.  Remove the water filter ( 

 ) from the box and put a 

replacement indicator sticker (Indicator sticker is included in the 

box) on the filter as shown. Place the sticker on the filter that 

dates six months in the future. For example, if you install the 

water filter in March, put the “SEP” sticker on the filter to remind 

you to replace it in September. This way, you can remember the 

time to replace the water filter. Normally, a filter life is about 6 

months.

4.   Remove the filter cap ( 

 ) and insert the filter into the filter 

housing.

5.    Slowly turn the water filter 90º clockwise to align with the 

printing mark on the cover, locking the filter in position. Make 

sure to align the water filter label mark ( 

 ) with center of cover 

filter printing as illustrated. Remember, do not over-tighten.

Installing the water filter.

After remove the right side upper shelf, you can install the 

water filter more easily.

Setting up your French Door Refrigerator

Reverse osmosis water supply

iMPoRtant : The pressure of the water supply coming out of a reverse osmosis  system going to the water 

inlet valve of the  refrigerator needs to be between 35 and 120 psi (241 and 827 kPa). 
If a reverse osmosis water filtration system is  connected to your cold water supply, the water pressure to the 

reverse osmosis  system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)

If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):
•   Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary.

•  Allow the storage tank on the reverse osmosis system to refill after heavy usage.

•   If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a 

reverse osmosis system. Remove the water filter.

If you have questions about your water  pressure, call a licensed, qualified plumber. 

Indicator sticker

(month indicator)

Turn until the label 

is aligned.

Cover filter.

Separation

of filter cap(red)

Be sure to flush the dispenser thoroughly or water may leak from it.

This is due to the fact that there is still air in the line.

Removing any residual matter inside the water supply line 

after installing the water filter.

1.   Turn on the main water supply & turn on the valve to the water supply line.
2.   Run water through the dispenser until the water runs clear (approx. 

6-7minutes). This will clean the water supply system and remove air from 

the lines.

3.  Additional clearing time may be required in some households.
4.   Open the refrigerator door and make sure there are no water leaks coming 

from the water filter.