Samsung WF8EF5E0W4W/EU User Manual

CAUTION: Do not put the drain hose in 
places of stagnant water or ponding. The 
water may flow back to the washing machine.

STEP 5 - Powering your washing machine

Plug the power cord into a wall socket, an AC 220 - 240V / 50Hz approved electrical outlet protected by 
a fuse or circuit breaker. (For more information on the electrical and grounding requirements, refer to the 
"Electrical supply and grounding" section on page 12.)

Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin 

 cycle 

after the installation is complete.

STEP 6 - Running Calibration Mode

Your Samsung washing machine detects the weight of the laundry automatically. For a more accurate 
weight detection, it is recommended running Calibration Mode immediately after installing the washing 
machine. Follow the steps below to run Calibration Mode.

Before running Calibration Mode, make sure that there is nothing in the drum or on top of the 
washing machine.

1.  Turn the washing machine off.
2.  Press the Power   button while holding down the Temp.   and Delay End   buttons 

simultaneously. 

The washing machine will turn on and "CLB" will appear on the display.

3.  Press the Start/Pause button to start Calibration Mode.
4.  The drum will rotate clockwise and counter-clockwise for about 3 minutes.
5.  When Calibration Mode is complete, "End" (or "0") appears on the display and the washing machine will 

turn off automatically. 

6.  The washing machine is now ready for use.

F400E(Bubble)-03633B-02_EN.indd   18

2017-02-27     5:23:52