Samsung WF8EF5E0W4W/EU User Manual
English - 37
06
TROUBLESHOO
TING
PROBLEM
ACTION
Fills with the wrong water
temperature.
•
Fully open both taps.
•
Make sure the temperature selection is correct.
•
Make sure the hoses are connected to the correct taps. Flush water
lines.
lines.
•
Make sure the water heater is set to supply a minimum 120 °F (49 °C)
hot water at the tap. Also, check the water heater capacity and
recovery rate.
hot water at the tap. Also, check the water heater capacity and
recovery rate.
•
Disconnect the hoses and clean the mesh filter. The mesh filter may
be clogged.
be clogged.
•
While the washing machine fills, the water temperature may change
as the automatic temperature control feature checks incoming water
temperature. This is normal.
as the automatic temperature control feature checks incoming water
temperature. This is normal.
•
While the washing machine fills, you may notice just hot and/or
just cold water going through the dispenser when cold or warm
temperatures are selected.
This is a normal function of the automatic temperature control feature
as the washing machine determines the water temperature.
just cold water going through the dispenser when cold or warm
temperatures are selected.
This is a normal function of the automatic temperature control feature
as the washing machine determines the water temperature.
Load is wet at the end of
a cycle.
•
Use the High or Extra High spin speed.
•
Use high efficiency (HE) detergent to reduce oversudsing.
•
Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
unbalanced and not spin completely.
•
Make sure the drain hose is not kinked or clogged.
Leaks water.
•
Make sure the door is properly closed.
•
Make sure all hose connections are tight.
•
Make sure the end of the drain hose is correctly inserted and secured
to the drain system.
to the drain system.
•
Avoid overloading.
•
Use high efficiency (HE) detergent to prevent oversudsing.
Has odours.
•
Excessive suds collect in recesses and can cause foul odours.
•
Run cleansing cycles to sanitize periodically.
•
Clean the door seal (diaphragm).
•
Dry the washing machine interior after a cycle has finished.
No bubbles are seen
(Bubbleshot models only).
•
Overloading may screen bubbles.
•
Severely contaminated laundry may not generate bubbles.
F400E(Bubble)-03633B-02_EN.indd 37
2017-02-27 5:24:00