Zebra 01407-000 User Manual
57
Programming
Parameter Settings
03/03/2009
TTP 1020™/TTP 1030™ Technical Manual
P1003643-001
Parameter Settings
Firmware 2.10 and Higher
The parameter order was changed in firmware version 2.10 in order to be standardized with
other printer models from Zebra.
other printer models from Zebra.
Some of the printer settings can be stored in the flash PROM so that they will be used also
after power is removed from the printer. When the printer is set up the way you like it to be,
you send ESC & 4, and the following settings will be stored.
after power is removed from the printer. When the printer is set up the way you like it to be,
you send ESC & 4, and the following settings will be stored.
Note •
All parameters can be stored in TTP 1030, while TTP 1020 only can store parameters,
parameters 5, 45, 47, and 57.
1
Baud
2
Data bits
3
Parity
4
Flow control
5
Disable parallel port signaling (only 1020)
7
Burn time
8
Max print speed
9
Loop ON/OFF
10
Printhead pulse control
12
Font attributes
13
Line spacing
14
Font
15-30
Tab positions
33
CR/LF
34
Autocut at FF
35
Black-mark synchronization
36
Variable document length
37-38
Minimum length / Fixed length setting
39
Max. black-mark length
40
Min. black-mark length
41-42
Feed between the black mark detection and cut (see ESC x)
43-44
Black-mark to first text line (see ESC Y)
45
Presenter mode
47
Eject calibration constant
49
Advance before cut
57
System