Acer altos s300
49
Installing a disk drive carrier
1.
Select the disk drive slot into which the disk drive carrier is to be
installed and remove the carrier blank, if there is one installed.
installed and remove the carrier blank, if there is one installed.
2.
Orient the disk drive carrier such that the LEDs are on the top.
3.
With the cam lever fully open, slide the carrier into the slot until
the lever starts to close (see figure on page 48).
the lever starts to close (see figure on page 48).
4.
Fully close the cam lever. The lever is fully closed, and the drive
locked in place, when the lever clicks into position.
locked in place, when the lever clicks into position.
Removing a disk drive carrier
1.
Using your finger, release the locking tab by pressing it in the
direction shown on page 48, and pull the cam lever towards you.
direction shown on page 48, and pull the cam lever towards you.
2.
Fully open the cam lever (approximately 90
o
to enclosure).
3.
With the cam lever open, wait for at least one minute to allow the
disk drive to spin down fully before removing it.
disk drive to spin down fully before removing it.
4.
Gently, pull the disk drive carrier out of the enclosure.
Caution: Immediately replace the disk drive carrier or install a
disk drive carrier blank to maintain correct airflow.
disk drive carrier blank to maintain correct airflow.
Note: This procedure applies to installing and removing the front
enclosure LED module also.
enclosure LED module also.