Apple imac 17in 1ghz Service Manual
78 - iMac (17-inch Flat Panel, 1GHz) Take Apart
AirPort Antenna
Warning: Whenever the bottom housing is opened for service, you must do two things:
1.You must clean the original thermal film from all thermal interface mating surfaces,
and reapply thermal paste to the mating surfaces on the thermal pipe.
and reapply thermal paste to the mating surfaces on the thermal pipe.
2. You must tighten the four torx screws on the bottom housing to a minimum of 17
in.-lbs. Use a torque driver (service tool 076-0899) to ensure that the thermal pipe is
firmly mated with the top base. If you do not have a torque driver, you must make
sure the screws are tightened by hand FIRMLY, BUT NOT FORCIBLY.
Failure to follow these steps could cause the computer to overheat and
damage internal components.
Refer to the topic “Thermal Paste Application” for detailed information.
Replacing the AirPort Antenna
Procedure
1.
Attach the replacement antenna to the outside of the Faraday cage. Feed the antenna
wires through the Faraday cage and position the wires against the Faraday cage (as
shown). Note: Make certain the wires lay flat against the Faraday cage.