Apple powermac g3 blue.white Service Manual
Troubleshooting
Symptom Charts/System - 32
the Logic Board” earlier in this chapter for instructions.)
7 Replace the logic board if the problem persists.
Fan on power supply
is running, but no
startup tone, screen
is black, drive not
accessed at startup,
and no LED on front of
system
1 Verify power supply voltage switch is set correctly for your
region (see “Voltage Switch” in Basics chapter for more
information).
2 Check jumper block configuration at J25. Make sure jumper
block is correct color for processor type installed (see
“Jumper Location J25” earlier in this chapter for more
information) and that it is installed in the correct direction.
3 Reseat processor module. Make sure locking arm is in down
position.