Juniper CBL-M40-PWR-AU10 User Manual
Connect the Router to Management and Alarm Devices
M40 Internet Router Hardware Guide
120
Connect to a Network for Out-of-Band Management
Connect the Routing Engine to a network for out-of-band management through the
MANAGEMENT ETHERNET
port on the craft interface. One cable with RJ-45/RJ-45 connectors is
provided with the router, as detailed in “Routing Engine Interface Cable and Wire
Specifications” on page 53. Follow this procedure:
Specifications” on page 53. Follow this procedure:
1.
Plug one end of the Ethernet cable (the connector is shown in Figure 48) into the
MANAGEMENT ETHERNET
port on the craft interface.
2.
Plug the other end of the cable into the network device.
Figure 48: Routing Engine Ethernet Cable Connector
Connect to a Management Console or Auxiliary Device
You can configure and manage the router on a system console connected to the Routing
Engine through the
Engine through the
CONSOLE
port on the craft interface, or on a laptop, modem, or other
auxiliary device connected through the
AUXILIARY
port. One RS-232 (EIA-232) serial cable
with DB-9/DB-9 connectors is provided with the router, as detailed in “Routing Engine
Interface Cable and Wire Specifications” on page 53. (If you want to connect a device to both
ports, you must supply another cable.)
Interface Cable and Wire Specifications” on page 53. (If you want to connect a device to both
ports, you must supply another cable.)
To connect a management console or auxiliary device, follow this procedure:
1.
Turn off the power to the console or auxiliary device.
2.
Plug the female end (shown in Figure 49) of the provided console cable into the
CONSOLE
or
AUXILIARY
port.
3.
Tighten the screws on the connector, using a 2.5-mm flat-blade screwdriver if necessary.
4.
Attach the other end of the cable to the console or auxiliary device.
Figure 49: Console and Auxiliary Serial Port Connector
1063
1027