Alcatel-Lucent omnistack 6124 User Manual
Using the System Configuration Program
2-46
802.1Q VLAN Static Table Configuration
Use this screen to create a new VLAN or modify the settings for an existing VLAN.
You can add/delete port members for a VLAN from any unit in the stack as a tagged
or untagged member. Or you can prevent a port from being automatically added to a
VLAN by the GVRP protocol.
You can add/delete port members for a VLAN from any unit in the stack as a tagged
or untagged member. Or you can prevent a port from being automatically added to a
VLAN by the GVRP protocol.
Alcatel OmniStack 6124
< 802.1Q VLAN Static Table Configuration >
VID
VLAN Name
Status
------------------------------
1
Active
Unit
Egress Ports
Forbidden Egress Ports
1.
111111111111 111111111111 11--
000000000000 000000000000 00--
2.
------------ ------------ ----
------------ ------------ ----
3.
------------ ------------ ----
------------ ------------ ----
4.
------------ ------------ ----
------------ ------------ ----
5.
------------ ------------ ----
------------ ------------ ----
6.
------------ ------------ ----
------------ ------------ ----
Unit
Untagged Ports
1.
111111111111 111111111111 11--
VID : 1
2.
------------ ------------ ----
[Show]
3.
------------ ------------ ----
[More]
4.
------------ ------------ ----
[New]
5.
------------ ------------ ----
6.
------------ ------------ ----
<Apply>
<Ok>
<Cancel>
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter
Description
VID
The ID for the VLAN currently displayed.
Range: 1-2048
Range: 1-2048
VLAN Name
A user-specified symbolic name for this VLAN.
String length: Up to 8 alphanumeric characters
String length: Up to 8 alphanumeric characters
Status
Sets the current editing status for this VLAN as: Not in Service, Destroy or Active.
Unit
Stack unit.
Egress Ports
Set the entry for any port in this field to “1” to add it to the displayed VLAN, or “0”
to remove it from the VLAN.
Forbidden Egress Ports
Prevents a port from being automatically added to this VLAN via GVRP. Note that
GVRP is not supported in the current firmware release.
Untagged Ports
You can add a port to the displayed VLAN as an untagged port by setting this field
to “1” or as a tagged port by setting it to “0.” This field is only enabled if the
corresponding port has been added to the displayed VLAN as an “Egress Port.”
[Show]
Use <TAB> or the arrow keys to select this field, then press <Enter> to display
settings for the VLAN specified in the VID field immediately above.
[More]
Use <TAB> or the arrow keys to select this field, then press <Enter> to display the
next consecutively numbered VLAN.
[New]
Use <TAB> or the arrow keys to select this field, then press <Enter> to set up the
screen for configuring a new VLAN.