Alcatel-Lucent omniswitch 8800-7700-7800 User Guide
BGP Configuration Overview
Configuring BGP
page 2-16
OmniSwitch 7700/7800/8800 Advanced Routing Configuration Guide
April 2006
BGP Configuration Overview
The following steps and points summarize configuring BGP. Not all of the following are necessary. For
the necessary steps to enable BGP on the OmniSwitch, see
the necessary steps to enable BGP on the OmniSwitch, see
.
1 Load the BGP protocol. See
2 Set up router-wide parameters, such as the router’s AS number, default local preference, and enable the
BGP protocol. See
BGP protocol. See
.
3 Configure peers on the router. These peers may be in the same AS as the router or in a different AS.
See
See
4 Configure peers that operate on remote routers. These peers may be in the same AS as the router or in a
different AS. See
different AS. See
.
5 Configure optional parameters. There are many optional features available in the Alcatel implementa-
tion of BGP-4. These features are described in later sections of this chapter. The following is a list of BGP
features you can configure on the OmniSwitch 7700/7800/8800:
tion of BGP-4. These features are described in later sections of this chapter. The following is a list of BGP
features you can configure on the OmniSwitch 7700/7800/8800:
• Local networks, or routes. See
• Route Dampening. See
• Route Reflection. See
.
• Communities. See
.
• Redistribution of routes from another protocol, such as RIP or OSPF. See