Alcatel-Lucent omniaccess User Manual
Configuring AAA Servers
83
Chapter 9
Authentication Servers
RADIUS Server Configuration
To add a new RADIUS server entry:
1. The values to the following parameters are required. A good habit would
be to collect this information for every RADIUS server that needs to be
configured prior to configuration. Individual values can be re-configured and
applied in case of errors and changes at any time.
be to collect this information for every RADIUS server that needs to be
configured prior to configuration. Individual values can be re-configured and
applied in case of errors and changes at any time.
2
Navigate to
Configuration > AAA Servers > RADIUS
page.
3
Configure the RADIUS settings.
Parameter
Description
Value in the
Example
Example
Server Name
< The name of the Authentication
Server >
Server >
Radius_Server_1
IP Address
< The address of the
authentication server>
authentication server>
192.168.100.1
Shared Secret
<The shared secret between the
switch and the auth server>
switch and the auth server>
Alcatel
Authentication
Port
Port
<The authentication port on the
server. Default 1812 >
server. Default 1812 >
1812 (default
maintained)
maintained)
Accounting Port
<The accounting port on the
server. Default 1813>
server. Default 1813>
1813 (default
maintained)
maintained)
Num of Retries
<Maximum number of retries sent
to the server by the switch before
the server is marked as down.
Default 3>
to the server by the switch before
the server is marked as down.
Default 3>
3 (default maintained)
Timeout
<The maximum time in seconds,
the switch waits before timing out
the request and re-sending it.
Default 5 seconds >
the switch waits before timing out
the request and re-sending it.
Default 5 seconds >
5 (default maintained)