Alcatel-Lucent omniaccess User Manual
OmniAccess RN: User Guide
168
Part 031650-00
May 2005
Configuring Denial of Service Attack Detection
Follow the steps below to configure Denial of Service attack detection:
1. Navigate to the
Configuration > Wireless LAN Intrusion Detection > Denial of
Service
page on the WebUI. To configure Rate Analysis, select
Rate Analysis
.
3.
Mark Unknown Access Points
as Rogue Access Points
as Rogue Access Points
In an environment where no
interfering APs should exist – for
example, a building far away from
any other buildings or an RF
shielded building – enable this
option to turn off the classification
process. Any AP detected that is
not classified as valid will be
marked as rogue.
interfering APs should exist – for
example, a building far away from
any other buildings or an RF
shielded building – enable this
option to turn off the classification
process. Any AP detected that is
not classified as valid will be
marked as rogue.
Note: Use caution when enabling
both “Mark Unknown APs as
Rogue” and “Disable Users from
Connecting to Rogue APs”. If the
system is installed in an area where
APs from neighboring locations can
be detected, these two options will
disable all APs in the area.
both “Mark Unknown APs as
Rogue” and “Disable Users from
Connecting to Rogue APs”. If the
system is installed in an area where
APs from neighboring locations can
be detected, these two options will
disable all APs in the area.