Alcatel-Lucent omni 6600 User Manual
OmniSwitch 6600 Family Chassis and Hardware Components
Viewing Basic Chassis Information
OmniSwitch 6600 Family Hardware Users Guide
September 2006
page 2-65
Viewing Basic Chassis Information
This section covers the following basic chassis information and monitoring commands:
Important Hardware Status Commands. Additional commands, used to view important hardware status
information, are described earlier in this chapter:
information, are described earlier in this chapter:
.
• For information on viewing chassis temperature status, refer to
.
• For information on viewing chassis fan status, refer to
.
Hardware Information
To view basic hardware information about the switch, enter the
show hardware info
command at the CLI
prompt. This command displays the following information:
• CPU type
• Flash and RAM memory information
• NVRAM battery status
• Jumper settings
• BootROM and Miniboot versions
For example:
-> show hardware info
CPU Type : PowerPC 8245,
Flash Manufacturer : SanDisk SDCFB-64
Flash size : 64094208 bytes (61 MB),
RAM Manufacturer : Kingston,
RAM size : 134217728 bytes (128 MB),
NVRAM Battery OK : YES,
Interrupt Boot Jumper : OFF,
Force UART Defaults Jumper : ON,
Run Extended Memory Diags Jumper : OFF,
Spare Jumper : ON,
BootROM Version : 5.1.5.115.R02,
Backup Miniboot Version : 5.1.5.115.R02,
Default Miniboot Version : 5.1.5.115.R02
show hardware infoshow moduleshow module long
(and
show ni
)
show chassisshow cmmshow session xon-xoff