Alcatel-Lucent omniacces-voip gateway User Manual

Page 5-51

Specify ISDN connection protocol for ISDN (BRI Euro) ports.

The 

command is used to configure the channel protocol mode for the 

ISDN ports at the voice daughtercard level. Specification of the protocol is optional.

To use this command, the voice daughtercard digital connection port type must be set to BRI 
Euro, or E1, or E1 ISDN PRI via the 

 command.

When this command is used, the J29 and J30 jumpers on the VSB daughtercard must be set 
accordingly for NT (LT)/TE, or damage to either the VSB and/or any connected device may 
occur. See also Chapter 2, “VoIP Daughtercards,” for details.

♦ Note ♦

When used separately, the terms E1 and ETSI both 
entail European PRI and BRI interfaces. E1 ETSI used 
together as one term refers specifically to Euro PRI.

Definitions:
slot

Specifies slot number of voice switching daughtercard installed in switching module, 
(e.g., 

).

Specifies physical port number on voice daughtercard, (e.g., 

).

Sets the ISDN connection protocol to network mode for PRI E1 (European Telecommuni-
cations Standards Institute (ETSI) standard protocol). For VSB only: 

 configures the port 

as NT (Network Terminator) /LT (Line Terminator).

Sets the ISDN connection protocol to user mode for PRI E1 (ETSI standard protocol). For 
VSB only: 

 configures the port as TE (Terminal Endpoint).

Sets the QSIG ISDN connection protocol to QSIG standard protocol for PRI E1; 
QSIG master (ETSI std. protocol).

Sets the ISDN connection protocol to QSIG standard protocol for PRI E1; QSIG slave 
(ETSI std. protocol).

Default:
The default setting is 

.

Command Examples: