Alcatel-Lucent omniacces-voip gateway User Manual

Page 5-57

Specify E1 ISDN bearer (“B”) channels. (Not available this release.)

The 

command is used to configure the type of switch 

connection for the ISDN ports at the voice daughtercard level. Specification of the ISDN 
protocol is optional if not using E1 ISDN PRI or BRI Euro.

Use the table and illustration above to determine valid bearer/data channel, slot and port 
values (applies to OS/R with two voice switching daughtercards).

Definitions:
slot

Specifies slot number of voice switching daughtercard installed in switching module, 
(e.g., 

).

Specifies physical port number on voice daughtercard, (e.g., 

).

Specifies bearer (B) channel number (e.g., 

) for E1 ISDN PRI; BRI Euro is limited to two 

bearer channels.

Specified identification number for related D channel.

♦ Syntax Notes ♦

The port connection type must also be set via the 

 command to indicate the number of channels 

availalble on the port, e.g., 3 channels (BRI Euro), 32 channels 

(E1 PRI ISDN).

Only 

 and 

are allowed for data channel numbers; control 

channel 

is reserved for signaling on E1 ISDN PRI, and 

is 

reserved for the BRI Euro control channel. For E1 ISDN PRI, 

channel 

 is used for framing (there is no framing on BRI Euro).

Bearer channels and corresponding Data channels must apply to 

to the same voice switching daughtercard.

Default:
For E1 ISDN PRI, the default channel values are 

,

. For BRI Euro, the default channel values are is 

.

Command Example: