Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-110
Command Usage
Specify Foreign Exchange Station Loop Start (FXS LS) time to wait before declaring off-hook.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling fxs ls seize detect
voice signaling channel <
slot/port/startChannel-endChannel
> fxs ls seize detect <
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value
Specifies the time to wait before off-hook condition is declared, in milliseconds from 1 to
5,000, (e.g.,
5,000, (e.g.,
150
).
♦ Syntax Note ♦
Do not use commas when entering the fxs ls time to wait value
before declaring off-hook condition (for example,
before declaring off-hook condition (for example,
1,000
will
return a syntax error message).
Default:
The default value is
The default value is
150
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 fxs ls seize detect 150
voice signaling channel 2/2/13-24 fxs ls seize detect 2500
voice signaling channel 2/3/1-30 fxs ls seize detect 5000
voice signaling channel 2/2/13-24 fxs ls seize detect 2500
voice signaling channel 2/3/1-30 fxs ls seize detect 5000