Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-113
Command Usage
Specify Foreign Exchange Station Loop Start (FXS LS) time to wait after supervisory discon-
nect before declaring on-hook.
nect before declaring on-hook.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling fxs ls supervisory disconnect wait
voice signaling channel <
slot/port/startChannel-endChannel
> fxs ls supervisory disconnect wait
<
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value
Specifies the fxs ls supervisory disconnect (CPC signal) wait value, in milliseconds from 1
to 60,000, (e.g.,
to 60,000, (e.g.,
200
) is generated before on-hook condition declared.
♦ Syntax Note ♦
Do not use commas when entering the fxs ls supervisory discon-
nect wait value (for example,
nect wait value (for example,
1,000
will return a syntax error
message).
Default:
The default value is
The default value is
200
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 fxs ls supervisory disconnect wait 200
voice signaling channel 2/2/16-24 fxs ls supervisory disconnect wait 30000
voice signaling channel 2/3/1-30 fxs ls supervisory disconnect wait 60000
voice signaling channel 2/2/16-24 fxs ls supervisory disconnect wait 30000
voice signaling channel 2/3/1-30 fxs ls supervisory disconnect wait 60000