Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-163
Command Usage
Override call signaling for detection of call progress tones (on/off/relative). This command
should only be used under the supervision of trained personnel.
should only be used under the supervision of trained personnel.
Syntax Options
voice signaling override in band call progress tones
voice signaling channel <
slot/port/startChannel-endChannel
> [no] override in band call progress
tones {on | off}
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
no
Optional command syntax.
♦ Syntax Note ♦
If
no
is used then ON and OFF cannot be specified.
on
Turns ON passing of in band call progress tones as voice data (after net-connect and
before tele-connect state) for specified telephony signaling channel.
before tele-connect state) for specified telephony signaling channel.
off
Turns OFF passing of in band call progress tone as voice data (after net-connect and
before tele-connect state) for specified telephony signaling channel.
before tele-connect state) for specified telephony signaling channel.
Default:
The default setting is
The default setting is
no override in band call progress tones
.
Command Examples:
voice signaling channel 2/1/1-12 no override in band call progress tones
voice signaling channel 2/2/13-24 override in band call progress tones on
voice signaling channel 2/2/13-24 override in band call progress tones on