Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-166
Command Usage
Override call signaling for in-band codec switching (on/off). This command should only be
used under the supervision of trained personnel.
used under the supervision of trained personnel.
Syntax Options
Remarks
In voice mode, this command enables switching from one in band codec to another by
detecting changes in the payload packet type.
detecting changes in the payload packet type.
voice signaling override in band codec switching
voice signaling channel <
slot/port/startChannel-endChannel
> [no] override in band codec
switching {on | off}
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
no
Optional command syntax.
♦ Syntax Note ♦
If
no
is used then ON and OFF cannot be specified.
on
Turns ON in band codec switching for specified telephony signaling channel.
off
Turns OFF in band codec switching for specified telephony signaling channel.
♦ Syntax Note ♦
To use this command, call signaling must be set to voice via the
call signaling
call signaling
voice, fax, modem, data setup
command.
Default:
The default setting is
The default setting is
no override in band codec switching
.
Command Examples:
voice signaling channel 2/1/1-12 no override in band codec switching
voice signaling channel 2/2/13-24 override in band codec switching on
voice signaling channel 2/3/1-30 override in band codec switching off
voice signaling channel 2/2/13-24 override in band codec switching on
voice signaling channel 2/3/1-30 override in band codec switching off