Alcatel-Lucent omniacces-voip gateway User Manual
Voice Switching Daughtercard — Euro BRI ISDN
Page 2-16
VSB Jumpers
The VSB daughtercard requires jumpers for Network Terminator (NT), also referred to as Line
Terminator (LT), and Terminal Equipment (TE), impedance, and power feeds, be set as
follows and in the order presented, e.g., NT (LT)/TE jumper/switch settings must be set on
the VSB before any other jumpers on the board. In general, the jumpers are set on a per port
basis. Locations of the jumpers are illustrated below.
Terminator (LT), and Terminal Equipment (TE), impedance, and power feeds, be set as
follows and in the order presented, e.g., NT (LT)/TE jumper/switch settings must be set on
the VSB before any other jumpers on the board. In general, the jumpers are set on a per port
basis. Locations of the jumpers are illustrated below.
VSB Jumper Settings — NT (LT)/TE, Impedance and Power Feeds
The jumpers are factory set on the VSB daughtercard, and should be changed by customers
only under the circumstances as listed below for each jumper. Note that, in general, only
jumpers which can be set with shunts are identified and described. Jumpers should be set in
the order in which they are presented.
only under the circumstances as listed below for each jumper. Note that, in general, only
jumpers which can be set with shunts are identified and described. Jumpers should be set in
the order in which they are presented.
♦ Note ♦
All VSB daughtercards are factory set to the defaults,
including but not limited to jumpers J16 and J18, J25
through J28, as well as J29 and J30, and the corre-
sponding NT (LT)/TE switches. This board is used
only to provide Euro BRI ISDN (E1 ETSI) capabilities,
and cannot be used in North America. See also VSD
Jumpers on page 2-12.
including but not limited to jumpers J16 and J18, J25
through J28, as well as J29 and J30, and the corre-
sponding NT (LT)/TE switches. This board is used
only to provide Euro BRI ISDN (E1 ETSI) capabilities,
and cannot be used in North America. See also VSD
Jumpers on page 2-12.
P31
VSB
FAIL
ERR
LINK
NT (LT)
Setting
to Left
Setting
to Left
NT (LT)/ TE
Toggle Switches
Power
Feeds
TE
Setting
to Right
J26
J25
J27
J28
J18
J16
MADE IN
U S A
P20
(Jumper and toggle switch
settings must match)
settings must match)
J20
J22
Default
J29 J30
P46
NT (LT)
/
TE