Alcatel-Lucent speedtouch 510 v5 User Manual
Chapter 3
Internet Access in No Time
E-DOC-CTC-20050429-0010 v1.0
16
Terminating the Home
Install Wizard
1
The SpeedTouch™ Home Install Wizard will configure the SpeedTouch™ and
your computer according to the service profile. You can follow the
configuration progress in following window:
your computer according to the service profile. You can follow the
configuration progress in following window:
2
Finally, click Finish to close the wizard. After some seconds, the Internet LED
will be lit green. If not, refer to
will be lit green. If not, refer to
.
3
You will be redirected to the embedded SpeedTouch™ pages automatically
(unless you cleared the http://speedtouch.lan check box in the previous
window).
(unless you cleared the http://speedtouch.lan check box in the previous
window).
.
IP settings
The SpeedTouch™ DHCP server is enabled by default. Therefore, the computer’s
networking interface, used during the Home Install Wizard procedure, is configured
for obtaining its IP configuration dynamically.
networking interface, used during the Home Install Wizard procedure, is configured
for obtaining its IP configuration dynamically.
These pages allow you to configure your firewall, device settings, and
so on. More information can be found in the SpeedTouch™ User’s
Guide.
so on. More information can be found in the SpeedTouch™ User’s
Guide.
For fixed IP configurations, please follow the instructions of your ISP.