Alcatel-Lucent speedtouch 605s User Manual

CLI Navigation

E-DOC-CTC-20040216-0004 v3.0

Command Line Interface Commands

Command Execution

All CLI commands are commands that operate on, or configure, the SpeedTouch™ settings.
The CLI commands can be executed:

•

from top level, preceded by the name of the command group from which the command should be executed.
E. g. firewall list.

•

from within the command group itself, using the reduced form of the command.
E.g. list at the firewall command group selection.

! in a command means ‘NOT‘, e.g. the [!]syn parameter in the firewall rule create command.

Entering a CLI Command

A CLI command can be entered in one of the following ways:

As a completely built-up command with all its parameters.
E.g. the command firewall assign hook=input chain=input.

Just the command itself without its parameters. After pressing Enter, you are prompted to complete the command 
with the required and the optional parameters.
The example below is the equivalent of the command firewall assign hook=input chain=input. 

•

For required CLI command parameter values, either enter a value or scroll through the possible values with 
the arrow keys.

•

For optional CLI command parameters, either enter a value or simply press Enter without giving a value.

This manner of entering a command is not applicable to all the CLI commands.
E.g. system config, upnp config, ...

=>firewall list
assign hook=input chain=input
assign hook=sink chain=sink
assign hook=forward chain=forward
assign hook=source chain=source
=>

=>firewall
[firewall]=>list
assign hook=input chain=input
assign hook=sink chain=sink
assign hook=forward chain=forward
assign hook=source chain=source
[firewall]=>

=>firewall assign hook=input chain=input
=>

=>firewall assign
hook

=

input

chain =

input

=>