Alpine nve-m300 User Manual

Page of 30
27
-EN
In Case of Difficulty
If you encounter a problem, please review the items in the following 
checklist. This guide will help you isolate the problem if the unit is at 
fault. Otherwise make sure the rest of your system is properly connected 
and completely charged. Contact your authorized Alpine dealer or 
Alpine directly at 1-888-NAV-HELP (1-888-628-4357).
The vehicle’s position is erroneous.
Drive the vehicle in an area of good GPS reception to allow the 
unit to recalibrate itself. Move to a location where strong GPS 
reception is possible.
No operation
The unit does not function.
If you incorrectly install the Box unit, malfunction will occur.
For installation instructions, refer to the Installation Manual.
The touch panel-compatible models (IVA-D105, IVA-W505, iXA-
W404, etc.) sold after 2004 can be connected to the unit. 
However, some units may not work, or some functions may not 
work, when connecting to this unit. For details, contact your 
Alpine dealer.
Reset
If malfunction occurs, disconnect the unit from the Power 
Vehicle Harness cable.
Specifications
• Due to continuous improvements, specification are subject to change 
without notice.
Reference
Moisture 
condensation
Allow enough time for the condensation to 
evaporate (about 1 hour).
Ambient 
Temperature
Make sure the temperature inside the vehicle 
is between -10°C and 50°C (14°F and 
122°F).
Blown Fuse
Replace the fuse of the same size.
Power Requirements:
14.4V DC (10-16V allowable)
Box Unit Size (W×H×D):
85mm × 25mm × 110mm
Box Unit Weight:
265g (9.3 oz)
Operating Temp:
-10°C to 50°C (14°F to 122°F)
Installation Angle:
Roll:±10 degrees
Pitch:±30 degrees
Yaw:±10 degrees
CPU:
SiRF Titan
GPS:
12 channel (32 channel 
acquisition) receiver
Internal Storage:
Built-in flash memory with Pre-
loaded Maps of US, Canada, 
Puerto Rico, and the Virgin 
Islands
USB Interface:
2.0