Alpine cxa-b200nk User Manual
Installation Guide
1
3
4
5
2
6
7
Your MobileHub™ for Nokia Handsets
The MobileHub™ you have purchased is designed to integrate
your mobile phone in the Alpine car radio system installed your
car. Please note that the components of the Alpine system and
the mobile phone are not included in the scope of supply of the
MobileHub™.
The MobileHub™ you have purchased is designed to integrate
your mobile phone in the Alpine car radio system installed your
car. Please note that the components of the Alpine system and
the mobile phone are not included in the scope of supply of the
MobileHub™.
Connecting diagram
Key:
Key:
Function
PARK
Ground contact if hand
brake on
brake on
BATT
Battery voltage +12V
MUTE
Radio mute
ACC / IGN
Ignition on
CALL 1, 2
Call establishment to pre-set
number for USA only
number for USA only
GND
Ground
LINE OUT
Audio outlet
MIC
Microphone inlet
RS 232
Interface to navigation system
Scope of Supply
(1) Advanced active car holder MCC-1
(2) Mounting plate MKU-1
Screw set KHH-S9
(3) MobileHub™ for Nokia Handsets CXA-B200NK
(4) Handsfree microphone HFM-15
(6) Ai-Net cable
(7) System cable SC-6
Installation guide
(1) Advanced active car holder MCC-1
(2) Mounting plate MKU-1
Screw set KHH-S9
(3) MobileHub™ for Nokia Handsets CXA-B200NK
(4) Handsfree microphone HFM-15
(6) Ai-Net cable
(7) System cable SC-6
Installation guide
ENGLISH
Copyright © Nokia Corporation 2002. All rights reserved.
Version 1.0
MobileHub™ for Nokia Handsets
CXA-B200NK
Important Notes
The instructions contained in this installation guide are general
guidelines which apply for the installation of the MobileHub™
in an automobile. However, due to the wide variety of car types
and models available on the market, this guide cannot consider
the individual technical requirements relevant for any particular
automobile. The information set out here serves solely as a
general overview.
The instructions contained in this installation guide are general
guidelines which apply for the installation of the MobileHub™
in an automobile. However, due to the wide variety of car types
and models available on the market, this guide cannot consider
the individual technical requirements relevant for any particular
automobile. The information set out here serves solely as a
general overview.
The MobileHub™ may only be installed by a qualified service
technician using the approved original Nokia components supplied
in the kit. Please note that non-observance of this requirement
will result in loss of warranty.
technician using the approved original Nokia components supplied
in the kit. Please note that non-observance of this requirement
will result in loss of warranty.
The MUTE cable must not be connected if the MobileHub™ is
used with the CDA-7998R.
used with the CDA-7998R.
For important safety information and/or instructions on the
operation, care, and maintenance of your Alpine system or your
Nokia mobile phone, please refer to the relevant User's Guide.
operation, care, and maintenance of your Alpine system or your
Nokia mobile phone, please refer to the relevant User's Guide.
Please read the basic safety guidelines set out
below before beginning any installation work.
below before beginning any installation work.
CAUTION
Disconnect the car battery before beginning with the installation
work and make sure that it cannot be reconnected inadvertently.
Do not smoke when working on the car. Make sure that there
is no source of fire or flame nearby.
Disconnect the car battery before beginning with the installation
work and make sure that it cannot be reconnected inadvertently.
Do not smoke when working on the car. Make sure that there
is no source of fire or flame nearby.
Take care not to cause damage to electrical cables, fuel or
brake lines, or safety equipment during installation work.
brake lines, or safety equipment during installation work.
Make sure not to impact the steering or braking systems or
other key systems essential for proper operation of the car
when installing car kit components. Check to make sure that
deployment of the airbag is not blocked or impaired in any
way.
other key systems essential for proper operation of the car
when installing car kit components. Check to make sure that
deployment of the airbag is not blocked or impaired in any
way.
RF signals may affect improperly installed or inadequately
shielded electronic systems in motor vehicles (e.g. electronic
fuel injection systems, electronic anti-skid (anti-lock) braking
systems, electronic speed control systems, airbag systems.
However, should you note a fault or change in the operation
of such a system, contact your car dealer.
shielded electronic systems in motor vehicles (e.g. electronic
fuel injection systems, electronic anti-skid (anti-lock) braking
systems, electronic speed control systems, airbag systems.
However, should you note a fault or change in the operation
of such a system, contact your car dealer.
The MobileHub™ may only be used at an operating voltage
of 12V with the minus pole earthed. Non-observance of this
requirement will result in damage to the car's electronic
system.
of 12V with the minus pole earthed. Non-observance of this
requirement will result in damage to the car's electronic
system.
Do not operate your MobileHub™ off the car battery for a
longer period of time, i.e. with the engine switched off, as
this may cause your battery to run dry.
longer period of time, i.e. with the engine switched off, as
this may cause your battery to run dry.
In order to comply with RF exposure requirements for mobile
transmitting devices, a minimum distance of 20 cm must be
maintained between the antenna and all persons.
transmitting devices, a minimum distance of 20 cm must be
maintained between the antenna and all persons.
Mounting Instructions
1 Advanced active car holder MCC-1
Should you wish to operate your Nokia mobile phone using the
phone's key pad, position the active swivel holder so that the
phone display is clearly visible and the keys easy to reach from
the driver's seat.
Connect the wires to the MobileHub™ as depicted in the
illustration.
1 Advanced active car holder MCC-1
Should you wish to operate your Nokia mobile phone using the
phone's key pad, position the active swivel holder so that the
phone display is clearly visible and the keys easy to reach from
the driver's seat.
Connect the wires to the MobileHub™ as depicted in the
illustration.
2 Mounting plate MKU-1
Use the screws supplied in the KHH-S9 kit and the MKU-1
mounting plate to fix the mobile phone holder in the car interior.
Select a suitable location on the dashboard or console, making
sure that the unit does not impair the driver when operating the
vehicle.
Use the screws supplied in the KHH-S9 kit and the MKU-1
mounting plate to fix the mobile phone holder in the car interior.
Select a suitable location on the dashboard or console, making
sure that the unit does not impair the driver when operating the
vehicle.
3 MobileHub™ for Nokia Handsets CXA-B200NK
Use the screws supplied to mount the MobileHub™ in a suitable
location which will allow the cables to be connected at the sides
of the device.
Use the screws supplied to mount the MobileHub™ in a suitable
location which will allow the cables to be connected at the sides
of the device.
4 Hands-free microphone HFM-15
Mount the hands-free microphone approx. 30 cm from the driver's
head and position it so that it points towards the driver's mouth.
Experience has shown that the best locations are near the rearview
mirror or to the left of the sun visor. Make sure to keep the
microphone at least 1 m away from the radio loudspeakers to
avoid feedback.
Mount the hands-free microphone approx. 30 cm from the driver's
head and position it so that it points towards the driver's mouth.
Experience has shown that the best locations are near the rearview
mirror or to the left of the sun visor. Make sure to keep the
microphone at least 1 m away from the radio loudspeakers to
avoid feedback.
Take care to mount the microphone so that it is not exposed to
air streams from the ventilators. Do not lay the microphone cable
in the heating, ventilation, or AC system. Use the adhesive tape
supplied to fix the microphone as it prevents noise from the car
body being transmitted into the interior.
air streams from the ventilators. Do not lay the microphone cable
in the heating, ventilation, or AC system. Use the adhesive tape
supplied to fix the microphone as it prevents noise from the car
body being transmitted into the interior.
You will hear the person you are talking to on your mobile phone
over the Alpine car radio loudspeakers. When you accept an
incoming call or an outgoing call is connected, the car radio
automatically mutes the audio source (music) and the call is
switched over to the loudspeakers.
over the Alpine car radio loudspeakers. When you accept an
incoming call or an outgoing call is connected, the car radio
automatically mutes the audio source (music) and the call is
switched over to the loudspeakers.
5 GSM Antenna (not included in the scope of supply)
Your MobileHub™ is designed to be connected to an external
GSM antenna. However, if your car is equipped with a combination
radio/GSM antenna with a frequency separating filter, this may
be used instead.
Your MobileHub™ is designed to be connected to an external
GSM antenna. However, if your car is equipped with a combination
radio/GSM antenna with a frequency separating filter, this may
be used instead.
6 Ai-Net cable
The Ai-Net cable supplied with your Nokia MobileHub™ will
allow you to connect the MobileHub™ to any device which
supports Ai-Net (see the Technical Requirements).
The Ai-Net cable supplied with your Nokia MobileHub™ will
allow you to connect the MobileHub™ to any device which
supports Ai-Net (see the Technical Requirements).
7 System cable SC-6
The system cable links the MobileHub™ with your car's electronics
system and with the Alpine car radio system. See the wiring
diagram for exact instructions. Please make sure that the PARK
cable is connected to the emergency brake contact of you will
not be able to utilize the entire range of features available.
(Some features may only be accessed when the car is parked
and the emergency brake is on.)
The system cable links the MobileHub™ with your car's electronics
system and with the Alpine car radio system. See the wiring
diagram for exact instructions. Please make sure that the PARK
cable is connected to the emergency brake contact of you will
not be able to utilize the entire range of features available.
(Some features may only be accessed when the car is parked
and the emergency brake is on.)
Wiring
The wiring diagram below shows the function of each of the
cables provided. When laying the cables, take care to position
them so that they are located as far as possible from the
electronics systems installed in your car in order to avoid
electromagnetic interference.
Make sure that cables are not subjected to mechanical wear
and tear (e.g. not laid under car seats or over sharp edges).
The wiring diagram below shows the function of each of the
cables provided. When laying the cables, take care to position
them so that they are located as far as possible from the
electronics systems installed in your car in order to avoid
electromagnetic interference.
Make sure that cables are not subjected to mechanical wear
and tear (e.g. not laid under car seats or over sharp edges).
Function Test
After your Nokia MobileHub™ has been installed, it needs to be
checked to insure that it is working properly. When testing the
function of the kit, also check that it in no way impairs the
driver during operation of the vehicle.
After your Nokia MobileHub™ has been installed, it needs to be
checked to insure that it is working properly. When testing the
function of the kit, also check that it in no way impairs the
driver during operation of the vehicle.
Operation
With the MobileHub™, you can choose to operate your Nokia
mobile phone using the phone's key pad or over the Alpine car
radio or navigation system.
With the MobileHub™, you can choose to operate your Nokia
mobile phone using the phone's key pad or over the Alpine car
radio or navigation system.
All phone calls made while the
mobile phone is in its holder will only run over the hands-free
microphone with voice output over the car radio loudspeakers.
microphone with voice output over the car radio loudspeakers.
For information on the operation of your mobile phone, please
refer to the Nokia User's Guide supplied with the phone. To
operate your mobile phone over the Alpine car radio, refer to
the Alpine User's Guide or follow the instructions shown on the
car radio or navigation system display.
refer to the Nokia User's Guide supplied with the phone. To
operate your mobile phone over the Alpine car radio, refer to
the Alpine User's Guide or follow the instructions shown on the
car radio or navigation system display.
The MobileHub™ includes a built-in hands-free feature which
enables you to make calls without holding the phone to your
ear. Now can choose to operate your Nokia mobile phone using
the phone's key pad or over the car radio or navigation system.
Since menu texts can be shown on the display of either the car
radio or the navigation system, this allows you to secure the
mobile phone holder out of the way at any convenient location
in the interior.
enables you to make calls without holding the phone to your
ear. Now can choose to operate your Nokia mobile phone using
the phone's key pad or over the car radio or navigation system.
Since menu texts can be shown on the display of either the car
radio or the navigation system, this allows you to secure the
mobile phone holder out of the way at any convenient location
in the interior.
Technical Requirements
Alpine Car Radios Supported
The MobileHub™ is designed for operation with all Alpine car
radio systems compatible to the Ai-Net (since 1998). If you are
using the CDA-7998R, you will be able to utilize the full range
of hands-free feature.
Alpine Car Radios Supported
The MobileHub™ is designed for operation with all Alpine car
radio systems compatible to the Ai-Net (since 1998). If you are
using the CDA-7998R, you will be able to utilize the full range
of hands-free feature.
Nokia Mobile Phones Supported
The MobileHub™ may be used with the following mobile phones:
Nokia 5110, Nokia 5130
Nokia 6110, Nokia 6130, Nokia 6150
Nokia 6210
Nokia 6310
The MobileHub™ may be used with the following mobile phones:
Nokia 5110, Nokia 5130
Nokia 6110, Nokia 6130, Nokia 6150
Nokia 6210
Nokia 6310