Aopen kf45 User Manual
Start To Handle
2.5 Set Up Motherboard
It is very easy to set up a motherboard in
A
Open
Baresystem. Just place the motherboard
in the correct position and tighten the screws. Please follow the steps below:
Read the handbook of the motherboard and adjust Jumper settings.
Currently almost all motherboards have a Jumper-free design (or Jumperless design).
Even so, there are still some other functions that need to be adjusted through Jumpers.
Please refer to the handbook of your motherboard and adjust the Jumper settings
according to your personal requirements.
Even so, there are still some other functions that need to be adjusted through Jumpers.
Please refer to the handbook of your motherboard and adjust the Jumper settings
according to your personal requirements.
Where should I screw the brass studs?
Please refer to your
motherboard handbook to
adjust the Jumper settings
according to your needs.
Before setting up the motherboard, you have to screw brass studs at the chassis of
housing to avoid the motherboard from directly contacting with the iron base. Please
compare your motherboard with your housing. Then just screw the brass studs you
need. The Motherboard you purchase may look different from the one shown below.
housing to avoid the motherboard from directly contacting with the iron base. Please
compare your motherboard with your housing. Then just screw the brass studs you
need. The Motherboard you purchase may look different from the one shown below.
Micro ATX Model
ATX Model
2-9