Alpine nvd-z001 User Manual

55

• The disc has been removed.
• There was no disc in the system when

the power was switched on.

• A disc that the system cannot read has

been loaded.

• The disc is dirty or upside down.

• The disc cannot be read because of

condensation.

• An attempt was made to search the

map from home with no home
registered.

• An attempt was made to search the

map from a memory point with no
memory point registered.

• An attempt was made to register more

than 200 points in memory.

• An attempt was made to set more than

5 destinations.

• When the destination or waypoint was

specified, there was no road in the
area, so no route could be found.

• Route could not be found for some

reason.

Insert the disc.

Insert the map disc.

Take out the disc, check if it was upside
down, clean it if necessary, then
re-insert it.
Take out the disc, allow enough time for
condensation to evaporate (about 1
hour), then re-insert the disc.

Register your home, then search the
map.

Register a memory point, then search
the map.

Erase unnecessary points, then register.

Focus on a nearby major road, then
specify the destination or waypoint
again.

Try to search for route again, or set
another location as destination.

No DVD.
Please insert map DVD.

Unable to read data.
Check if map DVD is correct.

Home is not registered.
Register in menu Memory
points.

No memory point registered.
Register in menu Memory
points.

Unable to set additional points.
Perform operation again after
deleting unnecessary points.

No roads possible for guidance
near destination. Please refer to
map.

Route could not be found.

Various messages are displayed on the monitor screen during operation. In addition to the messages
telling you the current status or providing guidance for the next operation, there are also the following
error messages. If one of these error messages is displayed, carefully follow the instructions in the
solution column.