Alpine nve-n055 User Manual

64

Reference

If you encounter a problem, please review the items in the following checklist. This guide will help
you isolate the problem if the system is at fault. Otherwise, make sure the system is properly
connected or consult your authorized Alpine dealer.

Blown fuse

Ambient temperature over
50°C

Moisture condensation

The vehicle position
changed after the ignition
was switched off.
• Movement on a ferry boat
• Rotation of a parking lot

turntable

• Movement by tow truck

Poor satellite configuration

Measurement is 2
dimensional

The navigation screen is off.

The disc is dirty.

The remote control batteries
are wearing out.

Auto reroute mode is not
set.

Replace with a fuse of the prescribed
rating.

Lower the temperature in the vehicle
below 50°C, for example by running for a
while with the window open or by using
the air conditioner.

Allow enough time for the condensation
to evaporate (about 1 hour).

Drive for a while with GPS signal
reception.

Move to a location where GPS satellite
reception is easy.

Press the ON button on the remote
control.

Clean the disc.

Replace the remote control batteries.

Select "Set-up" from the main menu,
then select Guidance Conditions. (See
page 56.)

No operation

The present
vehicle position
cannot be
measured
correctly.

The
measurement
error is too large.

Screen not
displayed

Cannot read disc
is displayed for a
certain operation.

Unstable
operation

No auto reroute