Aopen cd40x User Manual

Quick Installation Guide

Before  you  begin,  turn  off  the  system  power.  Follow  the  steps  below  to  install  the  CD-
ROM drive:

1. 

Adjust  the  Master/Slave  jumpers  on  the  back  of  the  CD-ROM  drive  as  necessary.
(The factory default of the slave mode normally should not be changed.)

2. 

Screw the CD-ROM drive unit into a free 5.25-inch drive bay.

3. 

Plug connectors to the sockets on the rear side of CD-ROM drive.

             

Cable Select

Slave

Master

NOTE: The  red  edge  of  the  IDE  cable  corresponds  to  pin  1  of  the  IDE
              interface on the CD-ROM drive.

In  most  cases,  software  applications  that  utilize  CD-ROM  drives  control  the  CD-ROM
drive  operations  directly.  However,  you  can  control  the  drive  manually  using  the  front-
panel controls.

1. Locate the tiny hole at the bottom of the disc tray.

Gently  poke  the  hole  three  times  with  a  sharp
needle or a clip.

2.  When  the  disc  tray  opens,  pull  out  the  tray  and

remove the disc from the CD-ROM drive.

Please refer to \Manual\Readme.txt for software driver installation and more information.

Red Strip

Power Cable

Audio Cable

IDE Cable

Red Strip

To digital audio

To Audio-In connector

of sound card