Aopen crw2040 User Manual
Hardware Installation
-- E-8 --
Rear Panel
Ÿ Power Connector
Used to connect to the host computer’s power supply (DC 5V/12V).
Be careful not to reverse the power connector when attaching it. A
reversed connection may cause damage to the equipment (not
covered by the warranty)
reversed connection may cause damage to the equipment (not
covered by the warranty)
Ÿ E-IDE Connector
Use a 40-pin double-end flat E-IDE cable to connect to the E-IDE interface.
Connecting or disconnecting connectors while power is on may result
in a short circuit, causing damage to the equipment. When connecting
or disconnecting connectors, make sure to turn off the power
beforehand.
in a short circuit, causing damage to the equipment. When connecting
or disconnecting connectors, make sure to turn off the power
beforehand.
Ÿ Audio Output Connector
Used to connect the sound card (analog signal).
Ÿ Digital Audio Output
Used to connect the sound card (digital signal).
Ÿ ATA mode setting Jumper (Optional)
The drive is set on “PIO mode 4” by default. You can set your drive on “UDMA”
mode by remove the jumper.
mode by remove the jumper.
Note: The compatibility of UDMA function is interrelated
with the chipsets of motherboard. If error occurs when
drive is writing after you set on UDMA mode, please plug
jumper back to set drive on PIO mode.
with the chipsets of motherboard. If error occurs when
drive is writing after you set on UDMA mode, please plug
jumper back to set drive on PIO mode.