Aopen crw5232 User Manual

Page of 29
 
 
Copyright 
© Copyright 2002 by AOpen Inc. All rights reserved. No part of this publication may be reproduced, 
transmitted, transcribed, stored in a retrieval system, or translated into any language or computer 
language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual 
or otherwise, without the prior written permission of AOpen Inc. All brand and product names are 
trademarks and/or registered trademarks of their respective holders. 
Disclaimer 
AOpen Inc. makes no representations or warranties, either expressed or implied, with respect to the 
contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular 
purpose. Any software described in this manual is sold or licensed “as is”. Should the programs prove 
defective following their purchase, the buyer (and not AOpen Inc., its distributor, or its dealer) 
assumes the entire cost of all necessary servicing, repair, and any incidental or consequential 
damages resulting from any defect in the software. Further, AOpen Inc. reserves the right to revise 
this publication and to make changes from time to time in the contents hereof without obligation to 
notify any person of such revision or changes. 
Federal Communications Commission (FCC) Statement 
This equipment has been tested and found to comply with the limits for a class B device, pursuant to 
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful 
interference in residential installation. This equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions may cause 
harmful interference to radio communications. However, there is no guarantee that interference will 
not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following measures: 
Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected. 
Consult the dealer or an experienced radio / TV technician help. 
FCC Warning 
Changes or modification not expressly approved by the party responsible for compliance could void 
the user’s authority to operate the equipment.