Aopen ir128con User Manual

Before you can connect your LAN to the Internet you must obtain an ISDN

internet account from your local Internet Service Provider (ISP). Your local ISP

should provide you the following information when you register with them:

1. Account user ID and password

2. Dial in telephone number, you may need to have two phone numbers if

you wish to run Multilink Point-to-Point Protocol (ie. MLPPP).

When the above information is ready,  you can configure the router with it to

connect your LAN to the internet. Configuring the router is very easy with the

quick config "qconfig" command.

The router will prompt you to enter the ethernet IP address for the router, the ISP

user ID, password, and the ISP phone number. When you’re done typing the

information, the router will return you to the CLI prompt. At this point we

recommend you to save all your configuration  by entering the command:

> config save

Now you are ready to launch the connection to the internet. To do this  please

use the connect command:

The router shall attempt to connect you with your local ISP. If succeed you should

see a message indicating that connection with the internet is successful.  At this

point, depending on weather your LAN has private IP addresses or not,  you may

want to configure NAT (Network Address Translation) to translate all of your

private IP addresses to the public IP address. This can be done with the this

command:

Simple as that!  Now you can start surfing.