ASUS mypal a600 User Manual

Avolites Pearl 2000 Operators Manual - page

 117

   P2000MAN.DOC  19/10/99 17:59

In Two Preset mode, the Playback Area behaves the same as Normal Run
Mode, and Memories and Chases programmed using Dimmers or Fixtures
on Preset Channels 31 - 60 will run as normal, even though these Channels
are not available on the Preset Faders.

See Section 13.3 The ADD and SWOP buttons in different Run Modes for
Playback ADD and SWOP button functions. The LED’s on the Playback
SWOP buttons follow the Playback Fader Level.

When you turn the Key back to Program, the Preset Faders work in Wide
mode again.

Overall levels are governed by the Grand Master.

⇒

 If you wish to record a scene set up in Run mode, make sure the scene

This is a Table showing how the SWOP and ADD buttons work in the
different run modes.

Preset

Playback

Run Mode

Adds that
channel onto
the output

Solos that
channel onto
the output

See

Appendix 5.
Functions of
the ADD
button in Run
modes

Solos the
Memory or
Chase onto
the output.

As in
Program
mode,
allowing
selection of
Preset
Focuses etc.

As in
Program
mode
allowing
selection of
instruments.

As normal
run, but the
response
time of these
buttons will
be slower.

As normal
run

As normal
run

As normal
run

As normal
run

You can change Run Modes two different ways.

Either :

•

 Turn the Key to Program.

•

 Press Softbutton B [USER SETTINGS].

•

 Use the Up and Down Cursor Keys to go down to Setting 4 and the Left

and Right Cursor Keys to cycle the Run Modes.

•

 Turn the Key to Run.