ASUS mypal a600 User Manual
Avolites Pearl 2000 Operators Manual - page
124
P2000MAN.DOC 19/10/99 17:59
⇒
YOU ARE ADVISED NOT TO ATTEMPT TO CHANGE THE SYSTEM
SOFTWARE JUST BEFORE SHOW TIME!!
To do this you need :
2 blank formatted 1.44 Mb disks to save your show and existing system
software onto.
2 disk labels and a pen
The disk containing the new System Software.
2 blank formatted 1.44 Mb disks to save your show and existing system
software onto.
2 disk labels and a pen
The disk containing the new System Software.
•
Turn Key to Program.
Puts you in Live Program Mode
.
•
Save your Show on a blank disk. Label it! See Section 13.1.3 Saving
your show to disk.
•
Turn the Key to System.
Puts you in System Mode
.
•
Press Softbutton A [SERVICE].
Puts you in the Service menu
.
•
Press Softbutton A [RUN AVOS 2].
•
Type in the Password 68340 and press ENTER.
Puts you in the AVOS menu.
•
Press Softbutton D [SAVE PROGRAM] and insert a blank preformatted
high density disk.
•
Press ENTER to Save your old System Software
. Not only does this back your
System Software up, but it double checks that the disk drive writes properly before you
dump the System!
dump the System!
•
Press Softbutton C [VERIFY] to check the Save.
Not only does this check
your save, but also it double checks that the disk drive reads properly before you dump
the System Software. If the Save or Verify was bad, try Saving and Verifying another
disk. If still unsuccessful, consult Avolites before proceeding.
the System Software. If the Save or Verify was bad, try Saving and Verifying another
disk. If still unsuccessful, consult Avolites before proceeding.
•
Assuming a successful save, remove the disk and label it OLD
SOFTWARE. WRITE PROTECT IT!
•
Insert the new System Software disk and press Softbutton B [BURN A
NEW PROGRAM] followed by ENTER.
This loads the new System Software
.
•
Once the System Software is loaded and the screen indicates that the
process is completed, press any key to exit the menu.
Puts you back in the
AVOS menu.
•
Press 1 on the keypad [Start the System] to start the system and
automatically do a WIPEALL.
Desk starts up.
•
Reload your Show from the disk made earlier in the usual way. See
Section 14.1.3 Loading a show from disk.
14.8 Loading a new AVOS operating system
You will need :
A blank disk.
The Disk containing the new AVOS operating system.
A blank disk.
The Disk containing the new AVOS operating system.
The file name for this is RAM.PRL
•
At this point, you need to look at the top line on the Screen. IF it says
Pearl 2000, then proceed to the next instruction. If not, you will need to
upgrade your AVOS to Pearl 2000. See section 14.8 Loading a new
AVOS operating system.
upgrade your AVOS to Pearl 2000. See section 14.8 Loading a new
AVOS operating system.