ASUS mypal a600 User Manual
Pearl 2000 November 1999 release notes - page
11
p2000.doc 12/11/99 18:34
4.13 Release notes display
The built-in release notes are displayed whenever the desk is switched ON.
Hit [ENTER] to disable the release notes screen. Once disabled the release
notes may be viewed at any time in SYSTEM by pressing [F] VIEW
RELEASE NOTES.
Hit [ENTER] to disable the release notes screen. Once disabled the release
notes may be viewed at any time in SYSTEM by pressing [F] VIEW
RELEASE NOTES.
NOTE that when the release notes are on view, the OK wheel, on the red 4-
character display, stops rotating even though the desk is operating normally
character display, stops rotating even though the desk is operating normally
5. Record Options explained
The record options are used when recording from new or updating, the
scene or ‘look’, in -
scene or ‘look’, in -
•
A memory
•
A chase step
•
A theatre stack step
Note the same effect is achieved whether the Program is in LIVE or in BLIND mode.
5.1 Record by CHANNEL
5.1.1 New Scene
For all of the fixtures that are in the programmer, only those channels will be
saved which are also in the programmer.
saved which are also in the programmer.
5.1.2 Updating a Scene
For all of the fixtures that are in the programmer, only those channels will be
saved which are also in the programmer.
saved which are also in the programmer.
5.2 Record by FIXTURE
5.2.1 New Scene
All of the fixtures and channels, in the programmer, will be saved.
If a fixture is present in the programmer but some or all of its channels are
not, then these channels will be taken from the stage.
not, then these channels will be taken from the stage.
5.2.2 Updating a Scene
All of the fixtures and channels, in the programmer, will be saved.
If a fixture is present in the programmer but some or all of its channels are
not, then these channels will be taken from the stage, but only if
not, then these channels will be taken from the stage, but only if
1. The channels are not already in the scene.
Or
2. The channels are in the scene but are recorded as absolute values
i.e. not preset focuses. This exception is here to protect against the
accidental overwrite of preset focuses, however, please note that the
other channels in the scene will be overwritten, so to avoid this make
sure that the scene to be updated is on the stage, alternatively set
the Record mode to Channel.
accidental overwrite of preset focuses, however, please note that the
other channels in the scene will be overwritten, so to avoid this make
sure that the scene to be updated is on the stage, alternatively set
the Record mode to Channel.