ASUS mypal a600 User Manual

Avolites Pearl 2000 Operators Manual - page

 54

   P2000MAN.DOC  19/10/99 17:59

This section assumes that you have devices patched on your Pearl, and that
you are comfortable controlling them.

These are different recording modes set in the USER SETTINGS menu.
Whichever mode is active when you Record or Edit a Memory or Chase is
the mode in which the Edits will be stored.

In this Mode, if you access any of the LTP Channels of a Fixture, all of the
LTP Channels of that Fixture will be put into the Programmer and stored into
any Memories or Chases programmed.

HTP Channels record as seen.

Only Channels that have been Edited are put into the Programmer.

This means that you can make Chases, for example, which have only
Intensity and Colour information in them. Because they have no Pan or Tilt
data, they will run the colour Chase over the Pan and Tilt settings from
another Memory or Chase.

HTP Channels record as seen.

Check you are in the correct Recording Mode before you start. See Section
6.1 Recording Modes.

•

 Turn the Key to Program. 

•

 Press CLEAR to clear the Programmer. (See 1.6 The Programmer for

more details.)

•

 Make sure all the Master Faders are at full and all the Playback Faders

are at zero.

•

 Create the scene you wish to record by selecting the appropriate Pages

of Fixtures and raising Preset Faders, and connecting the Wheels to
different Attributes to create LTP looks.
Alternatively use a Preset Focus to create a look. See Chapter 8 Preset
Focuses.

•

 Turn the Roller to the Facet you wish to record onto.

•

 Select Roller Page one, two or three. The Roller Page Buttons are

located to the left of the Roller.

•

 Press the blue MEMORY button on the Program Select bank.

 Its LED will