att 1339 User Manual
To make room for new messages, you should enter your Remote Access code after the two beeps, listen to
your messages, then delete some or all of the messages.
your messages, then delete some or all of the messages.
Turning on the System
If the system is not set to answer calls, but is still connected to AC power, you can turn it on when calling
from any touch tone telephone. (You do not have to enter your Remote Access code to use this feature.)
from any touch tone telephone. (You do not have to enter your Remote Access code to use this feature.)
1.
Dial you telephone number.
The system answers after ten rings by beeping twice. (The system will not play your announcement
message.)
2.
message.)
2.
Press and release 0.
The system beeps twice to indicate that the Automatic Answering feature has been turned on. When you
hang, up, the system remains on, ready to answer automatically and receive messages.
hang, up, the system remains on, ready to answer automatically and receive messages.
Note: If the system does not beep twice after you press 0, the system’s memory is full. You must enter your
Remote Access code, delete some or all of the messages, and press 0 again before the system can record any
new messages.
Remote Access code, delete some or all of the messages, and press 0 again before the system can record any
new messages.
After turning the system on, you can enter * to leave a message; enter your Remote Access code to access
other system features; or hang up.
other system features; or hang up.