att spirit attendant User Manual

studs or cross members), partially screw the

two screws into the wall at the marks,
remove them, hang the tabs on the screws,
and then tighten the screws.

For plaster, plasterboard, cinder block, or
brick surfaces, drill a 3/16" hole at each
mark and insert an anchor into each of the
holes. Gently tap each anchor with a ham-
mer until it is flush with the surface. Screw

the screws partially into the anchors, remove
them, hang the tabs on the screws, and then
tighten the screws.

Step 2 — Connect the  SPIRIT  Attendant
ConnecT/R to the controller and the  SPIRIT

Attendant to the  SPIRIT  Attendant
ConnecT/R.

dix A before proceeding. Consult with the
person who customized your  SPIRIT  System
before attaching the  SPIRIT  Attendant
ConnecT/R to the controller.

NOTE: The "4-wire cord" mentioned in the
steps below comes with the  SPIRIT  Atten-
dant ConnecT/R. Any cord you may have

that is connecting a  SPIRIT  Telehone to
the controller is also 4-wire cord .