Audiovox aps 500 User Manual
Model APS 500
Installation Manual
SELECTABLE FEATURES
Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be
certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Dip Switch Selectable Features :
Switch Number
ON Position
OFF Position
Factory Default
Dip Switch 1
Custom Code Override
Valet Switch Override
Custom Code Override
Dip Switch 2
Voltage Sense
Hardwire
Voltage Sense
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order to
begin the passive arming sequence.
RF Programmable Features :
Feature Selection
1 Chirp
2 Chirps
Default
First
1 Second Door Locks
3.5 Second Door Locks
1 Second
Second
Auto Lock On
Auto Lock Off
Auto Lock Off
Third
Auto Unlock On
Auto Unlock Off
Auto Unlock Off
Fourth
Headlight Output On
Headlight Output Off
Headlight On
Fifth
Passive Door Locks
Active Door Locks
Passive Locks
Sixth
Passive Arming
Active Arming
Active Arming
To program these selectable features;
Action
System Response
Turn ignition on
No response
Flip valet switch on then off 3 times
1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off
Short chirp, then long chirp
First
Then On
1 chirp = 1 second door locks
Press transmitter button 1 to change
2 chirps = 3.5 second door locks
or
Second
Flip valet switch on then off
2 chirps = auto locks off
Press tranmitter button 1 to change
1 chirp = auto locks on
or
Third
Flip valet switch on then off
2 chirps = auto unlock off
Press transmitter button 1 to change
1 chirp = auto unlock on
or
Fourth
Flip valet switch on then off
1 chirp = headlight output on
Press transmitter button 1 to change
2 chirps = headlight output off
or
Fifth
Flip valet switch on then off
1 chirp = passive locks
Press transmitter button 1 to change
2 chirps = active locks
or
Sixth
Flip valet switch on then off
1 chirp = passive arming
Press transmitter button 1 to change
2 chirps = active arming
or
Flip valet switch on then off
Exit program mode
or
Turn ignition key off
Exit program mode
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the
programming will be terminated.
Page 1