Audiovox aps-620 User Manual

Page of 12
1
128-7829
1 of 12
Model  APS-620
Installation Manual
This Remote Start System is designed to be used with
Automatic Transmission- Fuel Injection Vehicles Only!
COMPONENTS:
Control Module
2 Four Button RF Transmitters
Antenna/Receiver
1 1” X 1.75” Foam Pad
6 Pin Main Power Harness
7 Pin Accessory Harness
1 Hood Pin Switch
1/4” Female Spade Connector
2 Pin Door Lock/Unlock Harness
3 Pin Parking Light/Ground Harness
2 Pin LED Assembly
2 Pin Push-Button Valet/Program Switch
3 Pin Antenna Receiver Harness
4 Pin Auxiliary Output Harness
4 Philips Head Black Drill Point Sheet
Metal Screw #8 X 1/2"
Installation/Owners Guide
FEATURES:
-Selectable Ignition Lock & Unlock
-Selectable Door Lock/Unlock Output Timing
-Safe Start (Requires double push of the start button to engage the remote start
function)
-On-Board Parking Light Relay
-Trunk Release Output
-Horn Chirp Output With Selectable Duration
-Selectable RF Start Chirp
-Car Finder Mode (Can elect to have horn beep along with parking lights if
connected)
-Selectable Run Times 5, 10, 15, or 20 Minutes
-Selectable Gas or Diesel
-Automatic Start Timer (Can be set to start your car automatically at 2 or 4 hour
intervals)
-4 Negative Pulsed Aux Outputs Before Start, After Start, During Crank, After
Shutdown (To aid installation in many vehicles with factory alarm systems)
FCC NOTICE
This device complies with part 15 of the FCC rules. Operation of this device is subject to the
following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance voids the users authority to operate this device.