Audiovox professional series ca 5550sst User Manual

5

2010 Audiovox Electronics Corporation. All rights reserved.

1

BLACK/WHITE

ILLUMINATED ENTRY OUTPUT ( - )

This wire provides a  ( - ) 500mA output for 30 seconds when the system is
disarmed capable of driving relays.

Locate the vehicle’s dome light or pin switch wire.

Verification:  This wire will register positive voltage or ground when the
vehicle's dome light is turned ON.

2

BROWN/BLACK

HORN OUTPUT ( - )

Locate the vehicle’s horn wire.

Verification:  This wire will register at positive voltage and register
ground when the horn switch is pressed.

Connect the BROWN/BLACK wire to the vehicle’s horn wire. This is a low current
output, 500mA.

3

RED/WHITE

TRUNK RELEASE OUTPUT ( - )

Locate the vehicle’s trunk release wire at the trunk release switch.

Verification:  This wire will register either positive voltage or ground when
the trunk release is activated.

This is a low current output, 500mA.

4

BLUE/BLACK

IGNITION 3 / ACTIVE OUTPUT ( - )

The Active Output/Ignition 3 output wire provides a ground output when the remote
start function is activated and remains until 4 seconds after the remote start is
shutdown.  The Ignition 3 output wire can be used for several functions listed
below.  If this wire will be used for multiple application's a 1 amp diode is required
in-line with the stripe facing the control module.

Factory transponder (coded key) bypass.

General Motors VATS bypass, see the following diagram.  Use an SPDT relay (not
supplied).

Ignition 3 output, see the following diagram.  Use an SPDT relay (not supplied).

Accessory 2/3 output, see the following diagram.  Use an SPDT relay (not
supplied).