Axis 20443r2 User Manual

Check the boxes for the protocols that the user (IP address) will be allowed 

to use to access the camera. These can be FTP and/or HTTP. If you have particular 

requirements concerning which ports access will be allowed on, enter these in the Port 

range fields. To allow access via HTTP, the port value here must correspond to the value 

set on the TCP/IP Network Settings page. If this is set to some other value than 80 (the 

default setting), then this value must be added manually in this field. If the setting on the 

Network Settings page is 80, then nothing needs to be configured here.

After adding the above information click the OK button to save the changes.

If accessing the AXIS 230 via a proxy server, the proxy server's IP address must 

be added to the list of allowed IP numbers. 

To delete an IP address, select it in the list and click the Remove button. To modify an 

address, select it from the list of allowed addresses, make the necessary changes and then 

click OK.

Click Date and Time to define the time and date settings for the AXIS 230, either manually 

or automatically, as described below.

Shows the current date and time.

Select the time zone where the AXIS 230 is located.

Check this box to automatically update 

the time changes caused by daylight saving.

Sets the time according to the clock on your computer.

This option will cause the AXIS 230 to update the time from an 

NTP server every 60 minutes. Specify the NTP server's IP address or DNS name and set the 

appropriate time zone for your camera’s location. Note that if using a DNS name, a DNS 

server must be configured in the TCP/IP settings.

Using this option allows you to manually enter the time and date.