Axis 27505r1 User Manual
AXIS 216FD Installation Guide
Page 7
ENGLISH ENGLISH
3. Install the hardware
3a. Mount the camera
The AXIS 216FD can be mounted with the cables routed through the wall/ceiling, or from
above or below. There are cover plates for the openings on both sides of the dome cover. See
the illustations on page 4.
above or below. There are cover plates for the openings on both sides of the dome cover. See
the illustations on page 4.
To mount the AXIS 216FD on e.g. a drop (suspended) ceiling, it is important to check that
the ceiling material is strong enough to hold the weight of the camera.
the ceiling material is strong enough to hold the weight of the camera.
Please see www.axis.com for available mounting accessories.
1. Using the drill template, drill two holes in the ceiling/wall.
2. Route and connect all the required cables. See 3b. Connect the cables, below.
3. Fasten the camera unit to a ceiling or wall, using screws and plugs appropriate for the
2. Route and connect all the required cables. See 3b. Connect the cables, below.
3. Fasten the camera unit to a ceiling or wall, using screws and plugs appropriate for the
ceiling/wall material.
4. Ensure the camera is positioned so that the tamper-proof screws can be tightened using
the supplied screwdriver.
3b. Connect the cables
1. Connect the camera to the network using a shielded network cable.
2. Optionally connect external input/output devices, e.g. alarm devices. See page 5 for
2. Optionally connect external input/output devices, e.g. alarm devices. See page 5 for
information on the terminal connector pins.
3. Optionally connect an active speaker and/or external microphone.
4. Connect power, using one of the methods listed below:
4. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet). If available, this is automatically detected when the
network cable is connected (see above).
• Connect the supplied indoor power supply to the power connector on the camera.
5. Check that the indicator LED:s indicate the correct conditions. See the table on page 6
for further details. Note that some LED:s can be disabled and may be unlit.
!
IMPORTANT! - The casing of the AXIS 216FD is not approved for outdoor use
- the product may only be installed in indoor environments.
- the product may only be installed in indoor environments.