Axis 27756r1 User Manual

To access AXIS Camera Station from the Internet and get live images from the cameras you must open a set of 

IP addresses and port numbers in your firewall configuration. 

Basically there must be an HTTP port open for each Axis network camera/video server and one port for AXIS 

Camera Station. In order for AXIS Camera Station Client to have access to AXIS Camera Station over the 

Internet, port 11007 must be opened in the firewall/router. See the diagram below for an example of a firewall 

configuration.

Both AXIS Camera Station and AXIS ThinWizard software use port 80 as default. You must change the port on one of these programs if 
you intend to install them on the same server.

The NTFS file system must be implemented on your PC and the Indexing Service must be activated. This is done from the 
computer administration.

The partition of the hard disk where you save images must be NTFS formatted, which is the default in Windows 2000/XP 
and 2003 Server. For example, if the partition where you save images is “D:” and it is formatted as FAT32, you can 

convert it to NTFS by opening a command prompt and type: "convert D: /FS:NTFS /V". Make sure you type in the correct 
partitioned area of your hard disk.