Asrock 1core1333-2.66g User Manual

1 9

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

FDD connector

(33-pin FLOPPY1)

(see p.10 No. 19)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.10 No. 7)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors

These Serial ATAII (SATAII)

(SATAII_1: see p.10, No. 14)

connectors support SATAII

(SATAII_2: see p.10, No. 12)

or SATA hard disk for internal

(SATAII_3: see p.10, No. 10)

storage devices. The current

(SATAII_4: see p.10, No. 11)

SATAII interface allows up to

3.0 Gb/s data transfer rate.

Serial ATA (SATA)

Either end of the SATA data cable

Data Cable

can be connected to the SATA /

(Optional)

SATAII hard disk or the SATAII

connector on the motherboard.

Serial ATA (SATA)

Please connect the black end of

Power Cable

SATA power cable to the power

(Optional)

connector on each drive. Then

connect the white end of SATA

power cable to the power

connector of the power supply.

FLOPPY1

Pin1

the red-striped side to Pin1

connect the black end

to the IDE devices

connect the blue end

to the motherboard

80-conductor ATA 66/100 cable

IDE1

PIN1

SATAII_2

SATAII_4

SATAII_1

SATAII_3

connect to the SATA HDD

power connector

connect to the

power supply