Asrock 1333-d667 User Manual

CAUTION!

1. FSB1333-CPU will operate in overclocking mode. Under this situation,

PCIE frequency will also be overclocked to 115MHz.

2. About the setting of “Hyper Threading Technology”, please check page

28.

3. This motherboard supports Untied Overclocking Technology. Please read

“Untied Overclocking Technology” on page 24 for details.

4. This motherboard supports Dual Channel Memory Technology. Before you

implement Dual Channel Memory Technology, make sure to read the
installation guide of memory modules on page 16 for proper installation.

5. Please check the table below for the CPU FSB frequency and its corre-

sponding memory support frequency.

CPU FSB Frequency

Memory Support Frequency

1333

DDR2 533*, DDR2 667

1066

DDR2 533, DDR2 667

800

DDR2 400, DDR2 533, DDR2 667

533

DDR2 400, DDR2 533

* When you use a FSB1333-CPU on this motherboard, it will run at

DDR2 500 if you adopt a DDR2 533 memory module.

6. Due to the chipset limitation, the actual memory size may be less than

4GB for the reservation for system usage under Windows

XP, Windows

XP 64-bit, Windows

Vista

and Windows

Vista

64-bit.

7. Although this motherboard offers stepless control, it is not recom-

mended to perform over-clocking. Frequencies other than the recom-
mended CPU bus frequencies may cause the instability of the system
or damage the CPU.

8. While CPU overheat is detected, the system will automatically shutdown.

Before you resume the system, please check if the CPU fan on the
motherboard functions properly and unplug the power cord, then plug it
back again. To improve heat dissipation, remember to spray thermal
grease between the CPU and the heatsink when you install the PC
system.

9. The maximum shared memory size is defined by the chipset vendor

and is subject to change. Please check Intel

website for the latest

information.

10. Before installing SATAII hard disk to SATAII connector, please read the “SATAII

Hard Disk Setup Guide” on page 23 to adjust your SATAII hard disk drive to
SATAII mode. You can also connect SATA hard disk to SATAII connector
directly.

11. Power Management for USB 2.0 works fine under Microsoft

Windows

Vista

64-bit / Vista

/ XP 64-bit / XP SP1 or SP2 / 2000 SP4.