Audioline al702 User Manual
English
www.doro.com
21
Expanded System
Show RFPI Number
Note: Only used for installations with handsets from other manufacturers,
where the RFPI number is required.
1. Press
1. Press
w
.
2. Scroll to SETUP using the
{
/
}
buttons. Press
0
.
3. Scroll to BASE ID using the
{
/
}
buttons. Press
0
.
4. The display will show the base unit number (1, 2, 3 or 4). Press
0
to show
the RFPI number (usually 10 digits) will be displayed for up to 15 seconds.
Register a New Handset
Every handset must be registered in order to use a base unit, each base unit can
handle up to 5 handsets.
On registration the handset is allocated a handset number from 1-5.
Additional handsets can be purchased from your local retailer. See also the
Expanded Systems chapter for more information.
1. Press and hold the
1. Press and hold the
j
button on the base unit until the In-Use light starts
flashing. Registration mode will remain active for approximately 90 seconds.
2. Press
w
.
3. Scroll to REGISTER using the
{
/
}
buttons. Press
0
.
4. Select a number for the base unit you wish to register with by pressing the
relevant keypad digit (
1
-
4
). Any flashing numbers are unavailable.
5. Enter the current PIN number (0000 when supplied). Press
0
.
6. When the handset has found a base unit, the id-code of the base unit will
be shown on the display.
7. Press
0
to confirm.
8. If the registration is successful, the handset number will be shown on the
right hand side of the display.